Common Faults of Pure Water Equipment and Their Solutions

One of the common failures of pure water equipment: the high-pressure pump of pure water treatment equipment does not start and cannot produce water.1 Check whether there is a power failure and whethe...

One of the common failures of pure water equipment: the high-pressure pump of pure water treatment equipment does not start and cannot produce water.

1 Check whether there is a power failure and whether the plug has been inserted.

2 Check whether the low-voltage switch is malfunctioning, causing the power supply to fail to be turned on.

3 Check whether the pump and transformer oil are not short-circuited, or whether the entire pipeline is connected correctly.

4 Check whether the high-voltage switch or water level controller is malfunctioning and cannot be reset.

Common faults of pure water equipment 2: The high-pressure pump works normally, but it cannot make water.

1 may be caused by the pressure loss of the high-pressure pump.

2 The water inlet solenoid valve is faulty and cannot enter water.

3 The front filter element is blocked or the check valve fails.

4 The automatic flushing solenoid valve fails and is always flushed, making it impossible to close.

Common faults of pure water equipment 3: The high-pressure pump will not stop.

1 Due to insufficient pressure of the high-pressure pump, the pressure set by the high pressure cannot be reached.

2 The check valve is blocked, pure water or high-pressure failure cannot be generated, and it cannot take off.

---